Installing Tapco Intrafuse pivot springs can seem daunting, but with the right instructions and tools, it's a manageable task. This guide provides a step-by-step walkthrough, ensuring a smooth and successful installation. Remember, always prioritize safety and consult your firearm's manual before undertaking any modifications.
Tools You'll Need:
- Tapco Intrafuse Pivot Springs: Ensure you have the correct springs for your specific firearm model.
- Small Flathead Screwdriver: For carefully prying and manipulating parts.
- Punch (optional): A small punch can assist with aligning pins.
- Cleaning Kit (recommended): Clean your firearm thoroughly before and after the installation process.
- Work Surface: A clean, well-lit area to prevent parts from getting lost.
- Firearm Owner's Manual: Always refer to the manufacturer's instructions for your specific firearm.
Step-by-Step Installation Guide:
This guide provides general instructions. Always refer to the specific instructions that may come with your Tapco Intrafuse Pivot Springs and your firearm's manual. Improper installation can damage your firearm.
Disclaimer: The author and this guide are not responsible for any damage or injury resulting from the installation of these springs. This is for informational purposes only.
Step 1: Disassembly
- Safety First: Unload your firearm completely and visually inspect it to ensure it's clear. Double-check!
- Field Strip: Carefully disassemble your firearm according to the manufacturer's instructions. This usually involves removing the lower receiver, buffer tube, and trigger group. Take pictures at each step if you're unsure of reassembly.
- Locate the Pivot Pin: Identify the pivot pin that secures the lower receiver components.
Step 2: Spring Removal (if necessary)
- Existing Springs: If you're replacing existing springs, carefully remove them. Use a small flathead screwdriver to gently pry them out, paying attention not to damage any surrounding parts.
- Note Orientation: Pay close attention to the orientation of the old springs, as this will help you install the new ones correctly.
Step 3: Spring Installation
- Insert Springs: Carefully insert the new Tapco Intrafuse Pivot Springs into their respective locations. The springs are usually designed to fit snugly into their designated areas.
- Ensure Proper Seating: Make sure the springs are correctly seated and aren't bent or misaligned.
- Alignment: If necessary, use a punch to gently tap the springs into place.
Step 4: Reassembly
- Reverse Disassembly: Carefully reassemble your firearm following the reverse order of disassembly. Pay close attention to ensuring each component is correctly aligned and seated.
- Check Function: Before loading ammunition, perform a function check. Dry fire (without ammunition) several times to ensure the action cycles smoothly.
- Thorough Cleaning: Once complete, thoroughly clean your firearm and inspect all parts.
Troubleshooting:
- Difficult Installation: If you encounter difficulties during installation, consult your firearm's manual or the Tapco instructions. Seeking help from a qualified gunsmith is always an option.
- Spring Malfunction: If the springs don't function correctly after installation, double-check your work and ensure they're properly seated.
Conclusion:
Installing Tapco Intrafuse Pivot Springs requires precision and care. Following this guide and paying close attention to detail will significantly increase your chances of a successful installation. Remember, safety should always be your top priority. If you have any doubts, consult a qualified gunsmith.
